Empennage Fairing Work

Time: 2 Hours

In between different tasks I work a little on the empennage fairing. Basically I sand and add fiberglass/balloons to sand the next day. Each time I get closer to a perfect fit and a complete fairing. So far I pretty happy with the shape and fit now. Today I did a lot of sanding followed by adding a layer of tape to the lower right side to beef it up a little. 

Make no mistake about it this thing still needs a lot of work to be complete. There is still some shaping to be done on the leading edge as well as a million pin holes to be filled. 

Print Friendly, PDF & Email

Leave a Reply

Your email address will not be published. Required fields are marked *

*