VS Done

Time: 4 Hours

I got to work with the last couple of rivets for the VS forward spar. The next step has you cleco the skin on and begin to rivet starting at the center on the forward spar/center rib and work your way out. Then you work around the edge riveting the upper and lower ribs. Once that is done I inserted the rear spar and finished riveting it in place. I was able to use the squeezer for most of these rivets and finished up the rest with the bucking bar/rivet gun.
Next up the rudder!







Print Friendly, PDF & Email

Leave a Reply

Your email address will not be published. Required fields are marked *