Time: 1 Hour
I started sanding the inside surface of the fairing as it overhangs the roll bar. This area is visible and was in decent shape but needed some work. I filled in some depressions and sanded the surface good. I decide to clean up the transition from the edge of the windscreen to the surface of the fairing using some Super-Fill. I just used my finger like you would with caulking. 
After this cured I sanded all the edges smooth and filled in a couple areas and will sand them tomorrow. Next up will be pin hole filling on the inside and exterior surfaces. I plan to paint the inside black so that it doesn’t stand out.
