Wings Back On

Time: 6 Hours

We have been busy getting all the things done in the new home to make it ours. Like ripping up old ceramic tile to make way for new hardwood. That was not a fun project but it’s all ripped up and ready for the installers. In-between that work I have been doing little projects in the hangar to get it organized. I also got my hands on the RV to start building again. One of the items I was unhappy with when I put the wings on the first time was the length of the wire bundles coming out of the wings. I found them to be a little short to work on with the tight space you end up with when the wings are on. So since I had the wings off again I decided to add 12″ to each of the bundles to give me plenty of length. I also figured that I would finish up the little bit of fiberglass tasks to the control surfaces, the rudder and elevators. I just needed to fill some pin holes and smooth the transitions out a little. A composite pro I am not and hope to get some help when it comes painting time to make these perfect. I used some filler primer to identify the holes and used Super-Fil to make the corrections. With the rudder pin holes taken care of and a coat of primer on I put the rudder on the vertical stabilizer and bolted it in place. I also put the AeroLED tail light in as well.I then spent two hours putting in the new close tolerance bolts in to secure the wings…again. The process was just the same as before, I froze the bolts and used LPS lubricant. The rivet gun at low pressure worked to drive them into position. The hardest part of the whole ordeal, as before, was to torque the bolts. I worked one bolt and then took a little break as leaning over the side wall of the fuselage even with padding was not very comfortable. So that’s a good start to being in my very own hangar that’s ten feet from my back door! I can not wait to be able to just walk out and go for a flight or a trip.

Print Friendly, PDF & Email

Leave a Reply

Your email address will not be published. Required fields are marked *

*